Ventuz Forum

Hey All,

I play arround with the machine Config and the Live Project Management. I setup 2 computers. Both computers are in Group 1 (1.1 and 1.2). If I create a new presentation in the projects folder and upload it to the group it did not appear when I select the group. If I start the project on each machine (select the specific machine in the Machine Config Tool) via the machine config tool then I can see it and start it. The presentatios have the same project ID and the machines are running in cluster mode (master/client).
What did I missed to see and start the presentation directly in the live Project Management when I select the Group?

Cheers
S.

Hi Strohmy,

currently there is no auto-update implemented - you have to press F5 after the upload to see the new entries!

Cheers

Karol

Ok. This is working. But I still cannot start the presentation from the group because I cannot see it. I have to start it manually for each machine then the cluster is running and synched. I think there must be the posibillity to start the whole cluster with one click. I can see the default projects when I select the group butI cannot see my uploaded projects.

When you select the group, you should see all projects that are identical on all machines in the group. Ventuz uses a GUID to figure out which ones are identically. Sounds like this GUID is corrupted somehow. You could try to export and upload the project again.

Cheers

Götz