Hi,
When I'm working in the content view and I have a lots of nodes that grows the view inside total width and height. To move around in that space I use the mouse middle wheel click and drag but when I'm working on a node on the sides far from the center it actually refocuses the content view in the middle of my nodes every time I make a change. It's really annoying since I have to keep going back to the node I was working on.
Any thoughts on that issue?
Cheers,
Content View Revert to middle focus
Moderator: Support
Content View Revert to middle focus
Daniel
Professional 3D Integrator
Professional 3D Integrator
Re: Content View Revert to middle focus
I am using Ventuz Designer 5.3.5.616 R19649
Daniel
Professional 3D Integrator
Professional 3D Integrator
Re: Content View Revert to middle focus
Hi arthamas!
what do you mean with 'every time I make a change'?
Best Regards
Karol
what do you mean with 'every time I make a change'?
Best Regards
Karol
Re: Content View Revert to middle focus
Hi Karol,
Good question! I just did a test by creating a node connection and when I removed that connection the view got reset to the center area.
Cheers,
Good question! I just did a test by creating a node connection and when I removed that connection the view got reset to the center area.
Cheers,
Daniel
Professional 3D Integrator
Professional 3D Integrator
Re: Content View Revert to middle focus
Hi Karol,
Have you been able to reproduce that issue?
Do you need more details?
Cheers,
Have you been able to reproduce that issue?
Do you need more details?
Cheers,
Daniel
Professional 3D Integrator
Professional 3D Integrator