Page 1 of 1
Datapath Vision LC capture cards
Posted: 28 Feb 2018, 09:44
by Total-Image
Anyone successfully used the Datapath Vision LC capture cards (LC-HD2 or LC-SDI) with Ventuz?
Rogier
Re: Datapath Vision LC capture cards
Posted: 28 Feb 2018, 13:40
by Eric_RD
Have you tried the "Vision" drivers instead of the "VisionLC"?
https://www.datapath.co.uk/datapath-arc ... ll-v7-17-6
We only have "VisionSC" Displayport Cards, so I can't tell if it works for you...
Re: Datapath Vision LC capture cards
Posted: 28 Feb 2018, 14:04
by Dierk Ohlerich
From the manual : "Ventuz supports the Vision-AV and Vision-SC series, including the VisionSC-HD4+ board. "
Vision LC is new, and not yet supported. I am pretty sure we will add support for this, but no schedule has been made yet.
-- Dierk
Re: Datapath Vision LC capture cards
Posted: 28 Feb 2018, 14:08
by Total-Image
Yes, in our test system we have these SC cards as well.
It's already several weeks ago that I tested the LC card for the first time and what i can remember is that when I replaced the card with the LC Card it first worked (probably with the SC drivers) I then installed the LC drivers and it was not working anymore.
Tried to uninstall the LC drivers, reinstall the SC drivers, etc, but without any success.
According the manual, Ventuz does not support the LC range of cards.
Rogier