Ventuz Forum

Hi everyone.

This is my first post.

I have an external sound card ProFire 610. In stereo mode works perfectly. As soon as I switch it to multichannel mode and try to run Ventuz, this crashes.
The strange thing is that in the Configuration Editor shows all 10 channels.

Please help.

I was able to reproduce the problem. This should be fixed in the upcoming Ventuz 4.05.00 release. In the meantime, you should try to configure your interface to 8 (mono) channels, if that is possible.

For best quality and performance, all audio should be configured to 48000Hz. This is what Ventuz uses internally, thus avoiding sample rate conversion.

The bug is a little bit complicated, if you configure to 48000Hz and 10 channels, it should not crash, but audio will be silent, at least that is my analysis.

Thank you very much for checking this error.

You have 100% right.
After switching to 48 kHz sampling rate, Ventuz stopped crashes. As predicted card does not emits a sound.

Unfortunately I can not switch cards in 8 channel mode.
I have to wait for the patch.

When you plan to release version 4.05.00?

Release is scheduled for 23. Sept. 2014 !

I installed version 4.05 - here everything works perfectly - thank you.

Regards
Michael