Ventuz Forum

I think you'll need to be a bit more specific here, what kind of data do you want to draw your curve from? A set of co-ordinates? I have some discrete points now and I want to use the c# node to insert some data between any two points to make the line becomes smooth. Or is there a easy way to smoot...

Hi guys!
Is there a simple way to draw a curve based on the data?

Best regard!

So I need to set the two machines to client and master, respectively. Or two machines are set to single？ Question is, what are you doing?! The Master/Client setting you're talking about is used for the interaction (TUIO). If you're just using OSC to control things (like starting an animation) that ...

Thomas wrote:Thats the reason to use a Multicast Address in settings of your OSC-Software.
It will send the commands to all receiver within the range.
See:
https://en.wikipedia.org/wiki/Multicast_address

So I need to set the two machines to client and master, respectively. Or two machines are set to single？

cy001316 wrote:But the OSC software can only write one IP？

But the OSC software can only write one IP？

joschy wrote:the easy way is to use multicast IP's, take a look at the manual

Do you means that the Multicast Address in TUIO settings option?

But the OSC software can only write one IP？

I have two machines for the cluster rendering,they connect to the same local area network.One of the machine's mode networking is the Master another one is the Client.But when I use OSC to control , only one machine of the screen will switch, the other unchanged, that is to say, the picture of anoth...

Thank you for your reply. My os is windows7 and my directX version is 11.I think it might be my DirectX version is too high.Should I uninstall directx11 and then install direct9?

when I run Vpr, the system will prompt me: Could not initialize Ventuz Presenter/Runtime : Could not initialize any DirectX Device on your Graphics Card! But I have already installed DirectX11 in my system.What I should do to solve this problem.