Bug or Design?
Posted: 13 Dec 2013, 15:09
While trouble shooting touches using multiple outputs with either a blend or a bezel (Post http://forum.ventuz.com/viewtopic.php?f=21&t=3290 ) I needed to show the input Diagnostics in the VPR.
I was just using a single machine in local mode, so used "Alt Return" to make the VPR window smaller. Using the Configuration Editor/Live Mode I could turn on the 'Show Input Diagnostics" to see the mouse and touch positions but then making the VPR Output Full Screen turns this off. It seems that every time I "Alt Return" on the VPR to resize the output and get to the open Configuration Window behind , it clears the settings. Is this by design or a bug? Eventually using a second machine to turn the Diagnostics on.
I also find that only being able to use the interactive nodes in Design Preview and not in Production Preview a real pain as it necessitates creating A VPR each time for trouble shooting.
Regards
Peter
I was just using a single machine in local mode, so used "Alt Return" to make the VPR window smaller. Using the Configuration Editor/Live Mode I could turn on the 'Show Input Diagnostics" to see the mouse and touch positions but then making the VPR Output Full Screen turns this off. It seems that every time I "Alt Return" on the VPR to resize the output and get to the open Configuration Window behind , it clears the settings. Is this by design or a bug? Eventually using a second machine to turn the Diagnostics on.
I also find that only being able to use the interactive nodes in Design Preview and not in Production Preview a real pain as it necessitates creating A VPR each time for trouble shooting.
Regards
Peter