Page 1 of 1

Program port not connected cancels cueing on all machines

Posted: 15 Feb 2017, 18:25
by Kobbi
Hi guys,
I need to set topology of two ventuz machines for playout and one director which is realy simple. However I need one of ventuz machines to be primary and second one to be a backup. Here comes a catch.... If one of ventuz machines goes wrong and program port is disconnected, director does not cue any template because of port not connected error. Is there a way to force director to ignore this port not connected error and cue templates on alive computers?

Best regards,
Kobbi

Re: Program port not connected cancels cueing on all machine

Posted: 17 Feb 2017, 15:13
by Daniel Willer
Hi kobbi

Just additional topology just using the backup topology. In case of a failure you just switch the active Topology inside the Director.

Cheers
Daniel